Others also read
| A report has been commissioned by Thermoseal Group and produced by an independent warm edge consultant that shows a comparison of the thermal performance through the edge of insulated glass, including: Warm Edge Spacer Bar, Desiccant, PIB and Sealant.
| Melting glass is a very energy intensive process, with process temperatures of more than 1600°C required to melt the raw materials in the furnace.
| An Introduction to Design and Performance by Dr. Cenk Kocer - University of Sydney, School of Physics, Sydney 2006
| Transposing the EPBD in national laws, why it is so important for the glass industry?
| Everyone in Germany knows the expression “yellow angel”, and most of its 17 million members have already made use of the organization's road assistance service at least once: it is the largest automobile club in Europe, the ADAC.
| Insulating glass desiccants with different components give quiet disparate quality performances.
| In the façade industry, glass panes have been bonded to aluminium frames with UV-resistant silicone adhesives for 40 years with almost unchanged mechanical strength.
| The paper shows that the residual stress at the surface of tempered glass panels may vary both locally and globally, i.e., stresses near the edges and corners of the panels may be considerably different from the stresses in the middle part of the panels.
| The new Spiegel headquarters and the neighbouring office complex, the Ericus-Contor, a fourteen and nine-storey building pair, expand the gallery of internationally recognized architectural works in Hamburg.
| The canopies are a composite construction between both steel and glass, leaving no element without stress or structural function.
| Glass industry standards in different countries require 24/7 quality control with the same specifications and fully automated analyses and following statistics.
| Despite increasingly demanding requirements to save energy and a focus on reducing our use of prime energy, we also need to bear in mind economics and cost effectiveness during the construction phase of buildings, especially on larger projects.
| glassonweb.com dedicates the weekly focus to a technical article titled "A Sealed System for Heatable Glass - A New Product; the article is written by Prem Boaz, President of Glass Products Consulting LLC in Port Orange, Fla..
| At this year's GPD in Finland LiSEC was represented by two lecturers.
| SSV tested thousands of glass panes from 2000 according to the European Standards for thermally toughened safety glass EN 12150 and according to EN 1863 for heat strengthened glass.
| The new headquarters of one of the Worlds largest fashion groups features a glass curtain wall that combines the established benefits of DuPont SentryGlas interlayer with the new architectural fabric, SEFAR Architecture Vision, for a stunning visual effect.
| Firstly, it would be great if everyone in the glass industry refrained from calling this product “bullet proof” I seriously doubt if anything is ultimately bullet proof, bullet resistant is indeed the correct terminology and within the industry this is abbreviated to BRG.
| Process control is a key factor for speed and efficiency of IS machines. To run a machine at high performance levels it is essential to achieve and maintain stable production conditions.
| The energy loss associated with glass is a major concern for designers and owners. Heat loss in winter and overheating in summer represent a major portion of the heating and air-conditioning (AC) load, contributing significantly to the cost of operating a building.
| Wired glass is more dangerous than regular glass when it breaks because the exposed wires are razor sharp.
| Insulating glass panes of 5.0 x 2.3 m made of twice-laminated glass 16 mm thick and weighing about 925 kg had to be installed at a height of up to 45 meters as well as 18 mm thick enamelled special glass plates for the tower facing - and this in the 9° upward-sloping tower.
| Glass is a versatile material. Especially large area applications such as facade solutions impart their own visual effect and therefore require a targeted selection of the appropriate product.
| The use of transparent glass in conducting electricity using LEDs, short for light emitting diodes, is increasing. LED's are approaching the lifespan of standard building materials, making it cost effective to embed them directly in structural components and architectural finishes.
| To celebrate the 225th anniversary of Italys famous Nardini Distilleries, the Nardini family - who still owns and runs the company - treated themselves to an architectural work of art, erecting a stunning glass creation designed by Massimiliano Fuksas and Doriana O. Mandrelli.