Others also read
| Over half the world’s seven billion inhabitants live in cities, by the year 2050 the number will grow to almost ten billion. In order to avoid a climatic collapse in the metropolises, there is no other alternative to energy-efficient buildings.
| The recent issues related to energy saving and environmental sustainability in the construction sector are particularly problematic for professionals dealing with existing buildings, especially when buildings have a historic value...
| Melting glass is a very energy intensive process, with process temperatures of more than 1600°C required to melt the raw materials in the furnace.
| An Introduction to Design and Performance by Dr. Cenk Kocer - University of Sydney, School of Physics, Sydney 2006
| The paper shows that the residual stress at the surface of tempered glass panels may vary both locally and globally, i.e., stresses near the edges and corners of the panels may be considerably different from the stresses in the middle part of the panels.
| The canopies are a composite construction between both steel and glass, leaving no element without stress or structural function.
| Fused silica rollers are widely used to convey glass in high temperature environments, the tempering furnace being among the most demanding operations.
| Despite increasingly demanding requirements to save energy and a focus on reducing our use of prime energy, we also need to bear in mind economics and cost effectiveness during the construction phase of buildings, especially on larger projects.
| The following approach describes a new encapsulation technology for glass-glass-modules using tempered thin glass as front and back sheets.
| At this year's GPD in Finland LiSEC was represented by two lecturers.
| Was Fukushima like Chernobyl? There are those who say yes, and those who lean toward no. That is, from a purely technical point of view. But, in the eyes of the media, or of people’s awareness in general, the difference is huge.
| Energy savings are an essential part of any new or renovated building. These can be obtained by means of insulation, special glazing and the use of particular materials.
| The most recent technical development from LiSEC is that of a brand-new laminating tunnel, which was installed at one of its Italian clients’ plants late in 2010.
| “Casa Zero” produces more energy than it actually needs, creating a permanent cycle.
| Firstly, it would be great if everyone in the glass industry refrained from calling this product “bullet proof” I seriously doubt if anything is ultimately bullet proof, bullet resistant is indeed the correct terminology and within the industry this is abbreviated to BRG.
| Last week Safety Glass Experts signed a service contract with Romanian safety glass producer Gerom S.A. Buzau.
| In both the construction of new buildings and the refurbishment of existing ones there is an increasing trend towards construction materials with the highest possible energy efficiency.
| Benefits of the tempered glazing are well known and the tempered glazing is being utilized more and more in many different applications. Manufacturing technology in this area of safety glazing is developing fast.
| Large bus and special vehicle windscreens are produced with gravity bending method. Producing successfully this largest segment of vehicle glazing requires not just suitable equipment, but advanced skills, know-how, knowledge, and quality tooling, to name a few.
| Atomic Layer Deposition is a Chemical Vapor Deposition method based on saturating surface reactions.
| Advantages of the use of Radio Wave energy in the forming of glass and of tempering thin glass of less than 3.00mm. Some of the inherent problems in the conventional thermal tempering of thin glass are also presented.
| Forehearth operation is simple – you just set the temperatures you need on the zone controllers and away you go. In fact, it is so easy that the production department can attend to it alongside their real job of running the machine.
| During the past 15 years tempering of bent glass has mainly changed to horizontal methods.
| When new installations of flat tempering machines suited for architectural glass are discussed today, the option of convection technology is certain to be raised.
| Typical problems occurring during the heating process Heating is the most typical stage of glass tempering; a lot depend on this stage to bring out the product of high standard. Quality of tempered glass is very much influenced by