AAMA Releases New Voluntary Specification for Third-Party Finishes Applied to PVC Exterior Profiles

In the past, standards existed for extruders or window manufacturers when working with the paint process, but there was no AAMA standard for in-process quality control when painting was being done at outside contractors.

“From an applicator’s perspective, it gives the ability to substantiate that the application process is being followed to the defined standards,” says Mark Bamford (Milgard), Vice Chair of the task group. “From a manufacturer’s perspective, it gives them an additional quality check from their external vendor to make sure that application process is going correctly. It provides some oversight.”// Bamford adds that sometimes vendors may check paint and then store any unused excess, but then not test the remaining paint later. This will no longer be the case.

“This allows testing to occur at the point of application and not just at the receipt of product,” says Bamford. “It gives enhanced material quality control.”

AAMA 663-14, along with other AAMA documents, may be purchased from AAMA’s Publication Store.

More information about AAMA and its activities can be found via the AAMA Media Relations page or on the AAMA website, www.aamanet.org.

AAMA is the source of performance standards, product certification and educational programs for the fenestration industry.

SM - See more at: http://www.aamanet.org/news/1/10/0/all/1097/aama-releases-new-voluntary-specification-for-third-party-finishes-applied-to-pvc-exterior-profiles#sthash.rYOAYVnd.dpuf